Building a pergola or gazebo in Texas

Every DIY pergola, gazebo, arbor, or pavilion built in Texas has to contend with hurricane-force design wind speeds. Below is the practical, code-aware version of what those numbers mean for the way you build.

Footings: dig at least 12 inches

Texas's frost depth is approximately 12 inches. Per IRC R403.1.4.1, every footing under a structural post must rest at least 12 inches below grade and below the local frost line. Because the frost line is shallower than the 36-inch default in our plans, the standard footing spec is more than adequate. You can save concrete by reducing footings to 24 inches if your local AHJ allows.

Whichever depth you choose, always add 4 inches of crushed gravel at the bottom of the hole for drainage. Frost-heave damage is almost always caused by water freezing under a footing — gravel breaks the capillary path.

Wind load: 150 mph design wind

ASCE 7 / IRC R301 lists Texas at a design wind speed of 150 mph. This is hurricane territory. Add a Simpson H2.5A (or equivalent) hurricane tie at every rafter-to-beam intersection — not just every other one. Use through-bolted post-to-beam connections rather than lag screws, and consider upsizing posts from 6×6 to 8×8 on any structure with more than 120 sq ft of overhead area.

Seismic: Low risk category

Seismic risk in Texas is low. Standard lag-bolted post-base brackets and hurricane ties provide adequate lateral resistance for any structure in our library.

Permits: structures up to 200 sq ft are typically exempt

Most Texas jurisdictions follow IRC R105.2, which exempts accessory structures up to 200 square feet of floor area from a building permit — but always confirm with your local building department. The exemption usually does not waive zoning setback requirements, even if no permit is needed. If your structure attaches to a habitable building (a house wall, garage wall, or porch ledger), a permit is almost always required regardless of size.

Recommended wood species for Texas

Builders in Texas typically reach for Pressure-Treated Pine, Cypress, Western Red Cedar. The cold climate puts the most stress on horizontal exposed surfaces from freeze-thaw cycles. Specify rot-resistant heartwood and finish horizontal surfaces every 2 years.

Plans recommended for Texas

Every plan below is built from a wood species commonly stocked in Texas lumber yards and sized to fit within the 200-sq-ft permit-exempt threshold (where applicable).